Orafol ORATAPE HT55 Decorative Film Application Tape
4.0 to 4.5-mil, semi-transparent application tape with a specially formulated high-tack adhesive allowing the tape to stick to
silicone-coated release liners. Graphics stay flat with no tunneling after transfer tape is applied for smoother graphics and
Natural rubber, high adhesive power
Area of Use
The special composition of the adhesive enables problem-free premasking of die-cut or computer cut vinyl graphics;
especially decorative films, such as ORACAL® 631 Exhibition Calendered Film, ORACAL® 8810 Frosted Glass Cast Film,
ORACAL® 8510 Translucent Etched Glass Calendered Film, and ORACAL® 8710 Dusted Glass Calendered Film.
Thickness* (carrier and adhesive) 4.0 to 4.5 mil
Adhesive power (FINAT TM-1, after 20 min.) Adhered to stainless steel: 0.48 lb/in
Tensile strength Along: >17 lb/in
Across: > 17 lb/in
Elongation at break Along: 3%
Shelf life** 6 months
Minimum Application temperature > +60°F
Available widths (in inches)
6.5, 12, 14, 24, 30, 48, 54
*average **in original packaging, at 68°F and at 50% relative humidity
All ORATAPE® products are subject to careful quality control throughout the manufacturing process and are warranted to be
of merchantable quality and free from manufacturing defects. Published information concerning ORATAPE® products is
based upon research which the Company believes to be reliable although such information does not constitute a warranty.
Because of the variety of uses of ORATAPE® products and the continuing development of new applications, the purchaser
should carefully consider the suitability and performance of the product for each intended use, and the purchaser shall
assume all risks regarding such use. All specifications are subject to change without prior notice.
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
ORATAPE® is a registered trademark of ORAFOL Europe GmbH.