ORAFOL ORAJET 3751RA Wrapping Cast Gloss Vinyl with RapidAir


Select Size to see price.



ORAFOL ORAJET 3751RA Wrapping Cast Gloss Vinyl with RapidAir
2.25-mil, cast PVC film with a low initial tack adhesive, white gloss surface with RapidAir®
Release Liner
88# PE-coated silicone paper featuring advanced air release technology to facilitate quicker, easier application
Grey, solvent-based, repositionable, permanent low initial tack adhesive that, with heat, can be removed with little or no
adhesive residue for up to four years
Area of Use
Long-term, outdoor signage, and complex vehicle and fleet graphics
Technical Data
Thickness (without liner and adhesive) 2.25-mil
Dimensional Stability (FINAT TM-14) Adhered to steel, no shrinkage in cross direction;
In length, <.004” Temperature Resistance Adhered to aluminum, -58°F to +212°F, no variation Fire Behavior (DIN 75200) Fire Rating Adhered to steel, self-extinguishing ASTM E 84-07 Class “A” Adhesive Power (FINAT TM-1, after 24 h, average) Adhered to stainless steel: 4.1 lb/in Tensile Strength (DIN EN ISO 527) Along: Min. 19 MPa Across: Min. 19 MPa Elongation at Break (DIN EN ISO 527) Along: Min. 120% Across: Min. 120% Seawaterability (DIN 50 021) Adhered to aluminum, after 100h/73°F, no variation Shelf Life (68°F/50% relative humidity) 2 years Minimum Life Expectancy (based on accepted application procedures on vertical surfaces) 8 years (unprinted) Minimum Application Temperature 50°F Available Lengths Available Widths 150’ (50-yard) 30”, 50”, 54”, 60” Recommended Laminates ORAGUARD® Series 290, 290GF, 293 Print Compatibility Latex, Solvent, Eco-Solvent, UV Curable For best results, utilize ORAFOL ICC profiles available at and allow solvent-based inks to dry for at least 24 hours (48-72 hours preferred) at 70°F before cutting the graphic to the ink or applying a laminate. Note Surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination which could affect the adhesion of the material. Freshly lacquered or painted surfaces should be completely cured. The compatibility of selected lacquers and paints should be tested by the user, prior to application of the material. Films with structured surface are naturally more sensitive than the unstructured. Accordingly, these films are to be treated carefully both in processing and in cleaning. Impurities affect the appearance of structured films and require more frequent cleaning. Furthermore the application information published by ORAFOL is to be considered. The batch traceability according to ISO 9001 is possible on the basis of the roll number. IMPORTANT NOTICE All ORAJET® products are subject to careful quality control throughout the manufacturing process and are warranted to be of merchantable quality and free from manufacturing defects. Published information concerning ORAJET® products is based upon research which the Company believes to be reliable although such information does not constitute a warranty. Because of the variety of uses of ORAJET® products and the continuing development of new applications, the purchaser should carefully consider the suitability and performance of the product for each intended use, and the purchaser shall assume all risks regarding such use. All specifications are subject to change without prior notice.

Additional information

Adhesive Type






Surface Finish

Ink Type

, , ,

Media Type

, ,

Product Type



, , ,


BCI Offers SAME DAY FREE SHIPPING On All Regular Sized Items From all Distribution LocationsDistribution Locations