Orafol ORAGUARD 250AS
Orafol ORAGUARD 250AS
4.75 mil textured Vinyl Floor Cold Overlaminate.
• 3 month indoor durability for floor graphics.
• Protective laminate with high resistance to skidding and abrasion.
• ASTM C1028 tested for slip resistance.
Size: 54” x 150 ft
4.75-mil, matte transparent PVC film with a raised, skid-resistant, textured surface
55# silicone coated paper
Clear, solvent-based, permanent adhesive
A cold laminate for anti-skid protection of floor graphics. Meets the standards of ASTM D 2047 and BAM StVo §35 d3, (Federal
Office for Material Testing: Automobile Safety Act).
Thickness (without liner and adhesive) 4.75 mil
Temperature Resistance Adhered to aluminum, -40°F to +176°F, no variation
Fire Behavior (DIN 75200)
Adhered to steel, self-extinguishing
ASTM E 84-07 Class “A”
Adhesive Power (FINAT TM-1, after 24 h, average) Adhered to stainless steel: 2.74 lb/in
Tensile Strength (DIN EN ISO 527) Along: Min. 19 MPa
Across: Min. 19 MPa
Elongation at Break (DIN EN ISO 527) Along: Min. 130%
Across: Min. 150%
Seawaterability (DIN EN ISO 527) Adhered to aluminum, after 100h/73°F, no variation
Shelf Life (68°F/50% relative humidity) 2 years
Minimum Life Expectancy (based on accepted
application procedures on vertical surfaces)
Minimum Application Temperature 46°F
Available Widths (inches)
36, 40, 50, 54
Recommended to be used in combination with ORAJET® Series 1663
System Skid Resistance (Federal Office for Material
Testing: Automobile Safety Act)
Skid Distance Dry: <35”
Skid Distance Wet: <55”
ORACAL® recommends that printed film be allowed to dry for at least 24 hours at 70°F (48-72 preferred) before applying a laminate
Recycling Recommendation: Waste class similar to household waste, is to be recycled according to the local regulations.
Surfaces to which the material will be applied must be cleaned thoroughly of dust, grease or any contaminants. Freshly lacquered or painted
surfaces should be allowed to stand for at least three weeks after complete curing. The compatibility of selected lacquers and paints should be
tested by the end-user prior to use.
The statements in this information sheet are based upon our knowledge and practical experience. This data is intended only as a source of
information and is given without any guarantee and does not constitute a warranty. Due to the wide variety of possible uses and applications,
customers should independently determine the suitability of this material for their specific purpose, prior to use