Mojave LM3LL 3.0 mil. Luster Flexible Vinyl with UV Protection Overlaminates
With a Permanent Acrylic Adhesive and a 53 Paper Liner
Catalina Graphic Films Mojave Digital Media family of Overlaminates enhance overall graphic depth and gloss
while protecting printed materials from UV radiation, environmental elements and general abuse.
Fleet without Rivets
Face Film 3.0 ± 0.2 mils semi-gloss, clear, flexible vinyl
Adhesive 1.0 ± 0.1 mils P-22, clear, acrylic, pressureactivated,
Liner 53-lb. (3.1 ± 0.2 mils) white, polyethylenecoated-one-side,
Gloss Level Luster
Outdoor Durability Up to 5 Years Unprinted
This product is intended for use as an overlaminating film with slight
glare-reducing protective layer with luster properties on printed
substrates that are applied to indoor and outdoor surfaces such as
bus or automobile markings, buildings; signage; etc. Flat and simple
Product Thickness (Film Only) 3.0 – 3.2 mils
Minimum Surface/Ambient Air
Application Temperature +35° F.
Service Temperature Range -20° F to +150° F.
Water Resistance Good.
Solvent Resistance Good for most petroleum solvents and lower aliphatic alcohols.
For ultimate solvent resistance, edge sealing is recommended.
Adhesion 40+ oz. per lineal inch width (180 peel from Stainless Steel;
15-minute, room temperature dwell on test panel).
UV Resistance Up to 5 Years Unprinted
Shelf Life One (1) year when stored under conditions of 70°F and 50%
3.0 mil. Luster Calendered Vinyl With UV Protection. WITH A PERMANENT ACRYLIC ADHESIVE ON A 53 # PAPER LINERs
LM3LL3050A LM3LL5450A LM3LL6050A