Mojave CMTT100PR-OC 1.0 mil. Clear Polyester mounting film
Catalina Graphic Films has developed an optically clear, two-sided tape for mounting non-adhesive substrates.
This tape consists of a clear polyester film coated on one side with a clear permanent pressure sensitive
adhesive and on the other with a clear removable adhesive, with two clear, plastic release liners.
Face Film 1.0 mil Polyester Carrier Film
Adhesive P-82 clear acrylic pressure activated permanent;
65 ± 10 oz./lineal inch width
R-32 clear acrylic pressure activated removable;
6 ± 2 oz./lineal inch width
Release Liner 2.0-mil ± 0.2 mils clear polypropylene, silicone-coated on one side
(First release liner to be removed; adjacent to the permanent adhesive)
2.0-mil ± 0.2 mils clear, printed polypropylene, silicone-coated on
one side (Second release liner to be removed; adjacent to the removable adhesive)
Opacity Optically Clear
Indoor Durability Up to 3 Years
This product is intended to be used for converting a raw plastic film into
a removable, pressure sensitive material, where the installation is to be
optically clear, temporary, and clean removal of the signage is needed.
Total Product Thickness 7.0 ± 0.2 mils
Minimum Application Temperature +40ºF on Permanent Side; +50°F on Removable Side
Service Temperature Range -20° F. to +150° F.
Water Resistance Excellent: test piece (with vinyl face film applied) aged 24 hrs. applied to
stainless steel is not affected when immersed in 70ºF water for 24 hours
Good for most petroleum based solvents. Ultimate resistance to
solvents is highly dependent on the face film or substrate used.
Edge sealing is recommended in high solvent exposure areas
Shelf Life One year when stored at 70°F and 50% relative humidity
1.0 mil. Clear Polyester With a permanent acrylic adhesive on one side with a clear film liner and a removable acrylic adhesive with a clear printed film liner on the other side.
CMTT100PR-OC CMTT100PR385 CMTT100PR5150-CMTT100PR5450