Lumina 3000-002 White Intermediate 20 Drawing and Pounce Media Paper
FDC Intermediate 20 Drawing and Pounce Media Paper 002 White
FDC 3000 Series Intermediate 20# Drawing and Pounce Paper This product is ideal for hand painted signs or
stencils, and Cad pen plotters. Some vinyl cutter-plotters can use a pounce tool to create desired computer-aided
designs. Other methods would be using a plotter pen to draw the computer-aided design and then using a hand tool
with a star wheel to punch holes through the paper. Pounce powder would then be used to transfer the design onto
given substrate. To order punched material, use part number 3050.
3004 Series – FDC® 60# Drawing and Pounce Media Paper
Note: For further information regarding: printing, substrate cleaning, application, maintenance, durability
and removal please review the corresponding instructional bulletin available at www.fdcfilms.com.
Warranty: Data provided by FDC is for general information only. This data is not to be used for exacting specification purposes. Always pretest
product. Suitability for any given application is the responsibility of the user. Since FDC cannot control the conditions under which the
products referred to herein may be used or handled, it can make no guarantee as to the effectiveness, safety or applicability with respect
hereto. FDCs only obligation shall be to replace such quantity of product proven to be defective. FDC shall not be liable for any injury, loss or
damage, direct or consequential, arising out of the use or the inability to use the product. Before using, the user shall determine the suitability
of the product for his intended use, and user assumes all risk and liability whatsoever in connection therewith. The seller, FDC, shall not be
liable for any default or delay caused by contingency beyond its control or the control of its supplier including but not limited, short or reduced
supply of fuel, or other integral components of the product.
FDC 3004 Series 60# Drawing and Pounce Media Paper would be used where thicker paper is needed for
a larger handpainted sign or stencil is needed. 3004 can also be used in CAD pen plotters. Some vinyl
cutter-plotters can use a pounce tool to create desired computer-aided designs. To order punched material,
use part number 3054.
FDC 3000 Series part number 3054.